Serving Tomball from The Woodlands, TX

Concrete Leveling in Tomball, TX

Tomball's concrete takes the same beating as slabs across the rest of North Houston — Gulf Coast clay that shifts underneath, base material that settles unevenly, and driveways, walkways, and patios that end up sinking, tilting, or cracking as a result. Ghost Concrete Leveling is based in The Woodlands and provides mobile polyurethane injection service to Tomball driveways, sidewalks, patios, pool decks, garage floors, and commercial slabs, lifting settled concrete back toward grade without tearing it out.

We already work throughout The Woodlands, Conroe, and Spring, and this page covers what property owners along the Tomball Parkway corridor and the surrounding growth areas can expect when a slab starts to drop, crack, or pull away from the house.

Why Concrete Settles Around Tomball

Tomball is a mix of established neighborhoods built decades ago and newer subdivisions still filling in around the edges of town. Older driveways and walkways were often poured over base material that has since eroded or compacted unevenly, leaving a gap the slab eventually settles into. Newer construction sits on fill soil that needs time to fully settle, and a slab poured before that process finishes will often follow the ground down over the next few years.

The clay-heavy soil common across this part of Texas expands when it's wet and shrinks when it dries out, and that cycle repeats every season. Add in how quickly the area around Tomball has been developing — more rooftops, more pavement, more runoff finding new paths — and it's easy to see why so many slabs develop a low corner or a tripping edge within a few years of being poured. Polyurethane injection fills the void that's causing the movement and raises the slab back toward grade, though it doesn't change what the soil underneath is doing long-term.

Common Settlement Problems We Fix in Tomball

Driveway Settlement

A driveway panel that's sunk an inch or more at the garage apron or street transition creates a lip that catches car bumpers and trailer tires alike. It's one of the most common calls we get from homeowners in this area.

Sidewalk & Walkway Trip Hazards

Front walkways and sidewalk sections settle unevenly over time, leaving a raised or lowered edge that turns into a liability the moment someone catches a toe on it.

Patio & Pool Deck Settlement

Backyard patios and pool decks often settle at the edges first, pulling away from the house or tilting toward — or away from — the pool coping.

Garage Floor Low Spots

A garage floor that's dropped near the door or in one corner collects water and dirt, and makes itself obvious every time you park.

Porch & Entry Step Settlement

Front porches and entry landings can settle away from the foundation over time, leaving a gap or a step-down that's both a trip risk and an eyesore.

Concrete Leveling Services for Tomball Properties

Every service below uses our polyurethane concrete-leveling process — small injection ports, expanding structural foam, and a same-day cure. What changes from job to job is the slab type and how we approach access, thickness, and load.

Driveway Leveling

Sunken driveway panels and garage aprons can typically be raised back to grade with polyurethane injected through small ports, restoring the surface without a full driveway replacement.

Explore Driveway Leveling →

Sidewalk & Walkway Leveling

We lift sunken sidewalk and walkway sections so the surface transitions evenly again, addressing the trip hazard without tearing out the concrete.

Explore Walkway Leveling →

Patio & Pool Deck Leveling

Settled patio slabs and pool deck sections around Tomball backyards can often be raised and stabilized in place, closing gaps at the coping or the house line.

Explore Patio & Pool Deck Leveling →

Commercial Concrete Leveling

Retail lots, office walkways, and other commercial slabs in and around Tomball get the same mobile injection process, scheduled to minimize disruption to tenants and customers.

Explore Commercial Leveling →

Void Filling & Slab Stabilization

When a slab has a void underneath but hasn't visibly settled yet, filling that space with polyurethane can stabilize it before it turns into a bigger lift.

Explore Slab Stabilization →

How the Process Works

1. Evaluate the Slab

We walk the property, measure how far each section has settled, and check for cracking, drainage issues, or signs the slab isn't a good candidate for lifting.

2. Plan the Injection

We map out port locations based on slab thickness and the size of the void, aiming for an even lift without overloading any one section of the panel.

3. Fill and Lift

Polyurethane is pumped through small ports drilled into the slab, expanding to fill the void and raise the concrete back toward grade in a matter of minutes per section.

4. Patch and Review

Injection ports are patched, the surface is cleaned, and we walk the finished area with you to confirm the result before we leave.

Is Your Slab a Candidate for Leveling?

Most settlement problems we see in this area — a driveway panel that's dropped at one corner, a walkway section pulled away from a neighboring slab, a patio edge sinking near the yard — are good candidates for polyurethane lifting, provided the concrete itself is still structurally sound. Slabs with extensive cracking, crumbling edges, or exposed rebar are a different story, and lifting isn't always the right call once concrete has deteriorated that far.

The general rule: if the panel is intact and the problem is that it's sitting too low, injection can usually raise it. If the concrete itself has broken down, replacement may be the more practical option. Not every slab can be lifted, and we'll say so honestly during the evaluation if yours falls into that category. For a full breakdown of how to tell the difference, see our leveling-versus-replacement guide.

What Affects the Cost

Every property is different, so pricing depends on a handful of site-specific factors rather than a flat rate:

  • Total square footage of the slab or panel being lifted
  • How far the concrete has settled and how much material is needed to fill the void
  • Number of injection ports required for an even lift
  • Equipment access to the driveway, walkway, or backyard slab
  • Whether the job is residential or commercial in scope

For a general sense of pricing ranges across the region, see our concrete-leveling cost guide, or request a quote specific to your property.

Tomball-Area Coverage

We provide service throughout Tomball and along the corridor connecting it to our home base in The Woodlands, including areas near the Grand Parkway (SH 99), Kuykendahl Road, and Hufsmith Road, plus residential growth areas like Rosehill Reserve and Willowcreek Ranch. If you're not sure whether your property falls inside our service area, call us or send details through our contact page and we'll confirm before scheduling.

Tomball sits between a few other areas we serve directly. See our coverage for Klein concrete leveling, our The Woodlands service area, or our Houston coverage area for the broader North Houston region.

Project Evidence Near Tomball

We don't have completed Tomball projects to show yet — this page is part of expanding our service description to reach property owners here directly. What we can point to is regional work from the same crew using the same process: Concrete Leveling at Woodlands Lodge Apartments and Concrete Leveling at H-E-B Woodlands Market, both in The Woodlands. Neither is a Tomball job, but both reflect the mobile injection process we'd bring to a Tomball driveway, patio, or commercial slab. See the full list on our projects page.

Tomball Concrete Leveling FAQ

What causes concrete to settle around Tomball properties?

Most settlement comes down to soil movement under the slab — clay-heavy ground that expands and contracts with moisture, base material that erodes over time, or fill soil on newer construction that hasn't fully settled yet. The concrete itself usually isn't the problem; what's underneath it is.

Can a settled driveway panel be lifted?

In most cases, yes, if the panel is structurally intact and the issue is that it's sitting too low. We inject polyurethane underneath to fill the void and raise the slab back toward its original grade, usually without needing to replace the panel.

Can pool-deck concrete be evaluated?

Yes. Pool decks settle differently than driveways because of the coping line and the pool structure itself, so we evaluate each section individually before recommending a lift. See our patio and pool deck leveling page for more detail.

Is every cracked slab eligible for leveling?

No. If the concrete is intact and just sitting too low, lifting usually works well. If it's badly cracked, crumbling, or has deteriorated to the point of exposed rebar, replacement may be the better option, and we'll tell you if that's the case during evaluation.

What information is needed for an estimate?

Photos of the affected area, an approximate size of the slab, and a description of what's happening — a sinking corner, a trip hazard, a gap at the house — let us give you a preliminary read before we come out. You can send that through our contact page or call us directly.

Ready to Get Your Tomball Slab Leveled?

Send us photos and a few details through our contact page, or call us directly and we'll walk you through what's involved before any work begins.